Posted by stenobass on 03-03-2017 23:49
#1
Ciao,
just wondering if anybody tried to use a low B-string on their 4-string to tune it B-E-A-D...
Do you guys think a Status 4-stringer with a graphite neck trough contruction would suffer from this?
Thanks for any input!
Stefano
Posted by Jonathan Black on 04-03-2017 04:36
#2
Hi Stefano,
I've done that in the past on my wooden neck basses - had zero issues.
It would take a damn sight more more to cause a graphite neck to structurally fail! so be assured the additional tension will not effect it. - at most you may have to do a very minor truss rod adjustment, but considering the original graphite necks didn't even have a truss rod... i'd doubt you will even have to do that!
Few thing to consider:
The size of the nut (you may need to file it down for larger gauge B strings)
How "floppy" the strings are (can lead to fretbuzz etc) - this can be fixed by using higher gauge strings. or a longer scale length of the guitar,
4 string bass guitars tend to be 34 Inches - i know of a few players who custom ordered basses to 35 inches, so the strings are a higher tension thus play lighter gauge strings in the B-E-A-D configuration without having to worry about buzz.
Pretty much all 5 & 6 string basses tend to be 35inch + scale. Slightly off topic but i believe Carl Thompsons 4 string basses are 36inch scale!
Hope that helps,
Jonathan
Posted by stenobass on 04-03-2017 23:27
#3
Hi Jonathan,
thanks a lot for your detailed feedback!
To be honest, about 10 years ago I had already done it on my old Series II which does not have a truss rod and it worked fine.
Just wanted to know if that could have caused any issues on the neck...
Cheers,
Stefano